Sometimes we need to reinstall the Roots vacuum pump for some special reasons. However, equipment like this type is not installed casually. What else do we need to notice during the installation process? Let's learn together.
1. When turning on the power, pay attention to the motor steering. The steering of the motor shaft should be clockwise from the tail. The specific operation steps are to turn on the three-phase power of the motor and jog the motor start button to check if the steering is correct. , then swap any two of the three power terminals.
2. When the pumped gas contains dust or granular materials, a suitable air inlet filter should be installed at the inlet of the pump to prevent the dust or particulate matter from sucking into the pump chamber and damaging the Roots vacuum pump.
3, should be installed horizontally, the pump should be at least 300mm away from the wall or other objects, the oil window part of the pump should leave room for easy observation of oil level.
4. The pump and the pipe to be pumped should be clean, dry and leak-free. The pipe diameter should be as small as possible not less than the inlet of the Roots vacuum pump. The length should be short to reduce the pumping speed loss. There should be no leakage at the pipe joint.
5. The Roots vacuum pump should be installed in a dry, ventilated and clean place.
When installing a Roots vacuum pump, it is best to find a professional to install it, which is also the safest method. You can also carefully read the manual several times, and then install it after you understand it. After the installation is complete, you must check the equipment several times to see if there are any problems. After you have determined that there are no problems, you can use it normally.
